Newsletter

My Cart

Your Shopping Cart is Empty

Checkout

  • Edit Cart
  • Billing and Shipping Information
  • Shipping Method
  • Review & Payment
  • Finish

How the Portable Water-Mark Water Softener Works

We call water "hard" if it contains a lot of calcium or magnesium dissolved in it. Hard water causes two problems:

·It can cause "scale" to form on the inside of holding tanks, pipes, tea kettles and so on. The calcium and magnesium precipitate out of the water and stick to things like faucets and sinks, the side of your boat, RV and dulls your glass or plastic boat top.

·It also reacts with soap to form a sticky scum, and also reduces the soap's ability to lather so you use a lot more soap.

The solution to hard water is either to filter the water by distillation or reverse osmosis to remove the calcium and magnesium, or to use a water softener. Filtration would be extremely expensive so a water softener is usually a less costly solution.

The idea behind the Water-Mark Boat or RV water softener is simple. The calcium and magnesium ions in the water are replaced with sodium ions. Since sodium does not precipitate out in pipes or react badly with soap, both of the problems of hard water are eliminated. To do the ion replacement, the water runs through a bed of small plastic beads or through a chemical matrix called zeolite. The beads or zeolite are covered with sodium ions. As the water flows past the sodium ions, they swap places with the calcium and magnesium ions. Eventually, the beads or zeolite contain nothing but calcium and magnesium and no sodium, and at this point they stop softening the water. It is then time to regenerate the beads or zeolite. Regeneration involves soaking the beads or zeolite in a stream of sodium ions. Salt is sodium chloride, so the water softener mixes up a very strong brine solution and flushes it through the zeolite or beads (this is why you load up a water softener with salt). The strong brine displaces all of the calcium and magnesium that has built up in the zeolite or beads, and replaces it again with sodium. The remaining brine plus all of the calcium and magnesium is flushed out during the brining process.